Page 1 of 1

A tip for your wall panels.

Posted: Sat Sep 13, 2014 2:14 am
by Pinworthy
Hi Troy, been watching for a while and really enjoy your efforts. As for the tip, give some thought to using the table saw to rip a 45 degree angle on the top and bottom of each board. Doing this will give you a sort of tongue and groove boards. Depending on how badly the sides of the boards are you could do away with the rosin paper under the boards. Any way just a thought.

Re: A tip for your wall panels.

Posted: Mon Sep 29, 2014 9:03 am
by techman
Thank you for the idea. Actually I am planning to use the table saw to do that with the exterior siding.