Alternate Energy Projects Category



All Categories


Pages




Alternate Energy Projects

Latest in Alternate Energy Projects

How To Get Off The Grid For $5000 or less Video Series

I will show you how to take your home off the grid for $5,000 or less. This is the beginning of a series of videos which will walk you through the process of taking your home off the grid.   This means that no matter where you live, either a cabin, tent, RV, camper or full ho

Going Solar - Gutting out the electrical junk from my off grid trailer

Article from: April 26th, 2012   I have been converting my off grid trailer to solar for the last few months now. The last step in the process was to remove that old, bulky power converter and the 115 volt power cable that was normally used to

Passive Solar Window Heater For My Off Grid Camper

Article from: January 16th, 2012   I recently made a passive solar window heater for my off grid camper. It is simply a sheet of styrofoam with aluminum foil on one side, painted black. There are vent holes in the top and bottom to allow a

Getting started again with the H2O booster in my car

Article from: March 10th, 2011   Well, its been a long, cold winter and my Hydrogen Booster project had to be put on the side. I had a bad fuel pump just before the onset of winter, which caused the poor old car to sit for a while until I could

Normal daily use of my solar panel setup

Article from: August 29th, 2010     Well, my solar panels and battery bank are really proving their worth in my place. We loose power here about once a month, at least. It gets really frustrating to wake up in the dark with no way

Ran without Hydrogen Booster to compare results

Article from: August 29th, 2010   I have been running my car for the past few weeks without the H2O booster just to see what type of results I may see. I left all the modifications in place, but simply turned off the Hydroxy Booster. Th

Hydrogen Booster is working well in my old Honda

Article from: July 23rd, 2010   I have driven a few tanks of gas through my old Honda while using my new homemade hydrogen booster and here are the results: No savings on gas. Huge performance boost. The car has a lot more power and the

Set up solar lighting and started testing capacity of solar system

Article from: July 14th, 2010   I have installed LED lamps in my apartment to start testing capabilities of my new solar power system.   Even during rainy days, the solar panels are putting out power. We just had a few days

Update on materials used in making the hydrogen booster

Article from: July 23rd, 2010   After a couple weeks of running the diy hydrogen booster in my car, I have noticed some very important things and found a few problems.   At first, the lid kept coming loose. It is very hard

The Off Grid Project Explained

The Off Grid Project is a series of projects and experiments in alternate energy, off grid living and self sufficiency. This is the simple explanation and the line I have been using for years.   But many of my viewers on YT and DIY Tube have asked me what really is The Off Gr

Off Grid Chick Brooder For Raising Broiler Meat Chickens

Free energy off grid chick brooder for raising 30 meat birds (broiler chicks) for our homestead. This idea uses zero extra energy and no electricity to raise newly hatched chicks until they are strong enough to go outside. Newly hatched chicks cannot regulate their own temperature y

How To Build A Bedini Motor Series - Final Assembly

This is the finaly steps in the assembly of the Bedini Motor which can desulfate lead acid batteries and restore them to like new (or better) condition.   Today I soldered all the electronics components together following the schematic that John Bedini shared with us many yea

How To Build A Bedini Motor Series - The Coil Core

This is the next step in the How To Build A Bedini Motor Series - preparing the coil core. I am taking you step by step through building your own Bedini motor.   If you missed the parts list or the first video in the series, please see them below:  

How To Build A Bedini Motor Series - Wind The Coil

This is the next step in the How To Build A Bedini Motor Series - how to wind the coil. I am taking you step by step through building your own Bedini motor.   If you missed the parts list or the first video in the series, please see them below:  

How To Build A Bedini Motor Series - Attach The Magnets

This is the next step in the How To Build A Bedini Motor Series - attaching the magnets to the rotor.   This step does not require a lot of instruction but it is a little bit time consuming if you want to make it look good.   If you missed the parts list

ThruNite TN36 10,000 Lumen Handheld LED Flashlight

ThruNite flashlight company sent me their TN36 10,000 Lumen handheld LED flashlight to check out. This fits nicely in the palm of your hand but yet pierces the night like nothing else I have ever seen.   The package arrived with the flashlight, belt holster, spare gaskets and

How To Build A Bedini Motor Series ~ The Rotor Frame

This is the fourth article in the series How To Build A Bedini SSG (Simplified School Girl) motor. Today we are going to cover the frame which holds it all together.   A Bedini SSG is a pulse motor which has the ability to restore badly sulfated lead acid batteries using high

How To Build A Bedini SSG Step Two Label Magnet North Poles

This is the third article in the series on how to build a Bedini SSG (Simplified School Girl) radiant energy motor. This is a simple pulse motor that can restore lead acid batteries.   This motor has the ability to charge up multiple batteries on the charging side without dra

How To Build A Bedini SSG Step One The Rotor

Learn how to build a Bedini SSG step by step. You can restore lead acid batteries at home using this simple device. The Bedini motor can be build using all recycled materials so it can be made for free.   If you missed out on the parts list, please go back and get everything

Bedini Radiant Energy Hydrogen Browns Gas Generator

Radiant H2O Booster Bedini SSG Radiant Energy Hydrogen Booster

Restore Lead Acid Batteries With SSG Radiant Energy Battery Charger

Radiant Energy Battery Rejuvenator   How to Restore old Lead Acid Batteries Experience with a Bedini SSG battery charger and restorer. Lead acid batteries can often be a problem to dispose of. The

How To Build A Bedini Motor The Parts List

I am going to show you how to build a Bedini Motor - radiant energy device - step by step through articles and video. I will also help people through my support forum and answer any questions as needed along the way.   Viewers on my main YouTube channel have waited a long tim

Experiment Using A Bedini Motor And Capacitor For Faster Charging

In previous experiments I have put a capacitor in parallel across a battery terminals while being charged on my single coil Bedini motor. It seems that the battery charges faster. I had another battery as a control for comparison. Later I swapped out the two batteries to see what would happen.

Human Powered Free Energy Generator

I am not sure what I have stumbled on here but I can charge up capacitors by holding a coil of wire in my hand. I was experimenting with aerial antenna energy gathering when I discovered that I was harvesting more energy from myself than from the air.   I built a small aerial

Free Energy From The Earth Using Earth Battery

You can make a battery using a simple nail and a piece of copper wire stuck in the ground. With a volt meter you will see a voltage between the two pieces of metal. Any two separate pieces of metal will give you a potential difference (voltage) between them if stuck in the ground.  

Bedini Motor Capacitor Across Battery Shows Higher Charging Output

I have been experimenting with my old Bedini motor quite a bit recently and performing experiments in an attempt at increasing its output. A capacitor placed in parallel with a battery seems to increase the charging output of that battery.   Some people theorize that the capa

What Is Free Energy And Can We Use It

For a few years I have avoided the words "free energy", "radiant energy", "cosmic energy" and others on my main channel due to the fear of people becoming angry and leaving. But now that I separated electronics from my main channel I am free to say what I want here.   For tho

Single Coil Bedini Charging Multiple Batteries With No Extra Current

Previously I tried charging up to 7 batteries at one time with my single coil Bedini motor using a new diode for each battery pair. Now I have ammeters to show the input and output current. The input current remains the same no matter how many batteries I add to the output.  

Single Coil Bedini Motor Charging 7 Batteries & Increased Output w Capacitor

The other day I experimented with my single coil Bedini motor by charging a second set of batteries using only a second diode. Today I expanded that to a total of 7 batteries being charged with no increase on the input current. A capacitor across the batteries actually seems to increase the outpu

Single coil Bedini motor charging 4 batteries w no current increase

When I built my first Bedini motor many years ago I was charging up 5 different batteries on the single coil machine and a single transistor. I used a diode from the collector for each battery. I did not have meters and gauges at that time so I never tested it out. But it worked.  

Higher voltage output with Bedini Motor And Capacitor

I got the idea of trying a capacitor in series with the output battery of my Bedini SSG motor. I previously set up 19 LED lamps in series with the output. With the capacitor I got 60 to 80 volt spikes on the output of my Bedini motor.   First of all I put a digital volt, amp

Bedini Motor Increased Charging Running 19 LED Lights & Reduced Current

I wanted to see if I could get some free light from the output of my Bedini motor while charging a battery. I ended up with 2 incandescent lights and 19 LED lights with reduced input current and increased output charging.   I first got the idea of trying an incandescent light

Bedini Style Motor Using Car Relay - Imhotep design

People have been asking me for a long time to show them how to make a Bedini motor. While I am gathering up the materials to make a full scale motor I will show you how to make a small one using a car relay.   This is a design from a man called Imhotep on the internet. I have

Sun Coffee - Brewing Coffee By The Power Of The Sun

I found a submersible water heater the other day for just over $2 so I got it to use in my off grid work shop. I can now make my afternoon coffee for free using the power of the sun.   My off grid work shop is powered by solar panels. This submersible water heater is rated at

Assembling The Q3 Charge Accelerator Toroidal Section

I am assembling the Quanta Magnetics Q3 Charge Accelerator toroidal section. This is the third and final section of the three stage pulse motor generator. I have the pulse motor and energizer section running already.   I have been running experiments on the pulse motor and ge

Experiments With The Quanta Q3 Pulse Motor & How A Pulse Motor Works

Now that the Quanta Magnetics Q3 Charge Accelerator pulse motor section is finished and running I am performing various experiments with it for a while before moving on to building the energizer/generator section.   The Quanta Magnetics Q3 Charge Accelerator is a three part m

Finished Assembling The Q3 Pulse Motor Generator & First Run

I finished assembly of the Quanta Magnetics Q3 pulse motor section of the motor/generator and got it running for the first time. It took me quite a while to figure out the timing but eventually I got it.   I finished connecting the diodes and solid state relay to the metal pl

Putting The Q3 Generator Motor Rotor & Stator Halves Together

I brought the Quanta Magnetics Q3 Charge Accelerator downstairs to the tiny house dining room table for final assembly of the pulse motor section.   I tightened down the rotor retaining screws on both sides of the rotor assembly to make sure there are no gaps between the acry

Q3 Charge Accelerator - Pulse Motor Work Continues

Work on the Quanta Magnetics Q3 Charge Accelerator continues. I am excited about getting this running as soon as possible. I hope that it will, at the very least, desulfate lead acid batteries for our off grid homestead.   First I finished assembly of the electronics control

Assembly Of Q3 Charge Accelerator Pulse Motor Continues

I am working on the Quanta Magnetics Q3 charge accelerator which is a pulse motor battery charger. My hopes are to be able to keep my off grid homestead batteries in good shape with this device for many years to come.  

Why Pulse Motor Desulfator Is Important To Off Grid Homesteads

Why is a pulse motor/battery desulfator important to an off grid homestead. This is a device which can restore sulfated lead acid batteries to like new condition or even better. I explain why here.   As I work on the Q3 charge accelerator many people are asking me why this is

Soldering The Wires On Charge Accelerator Stator Half

I picked up some 18 gauge wire and started to solder the wires on the stator half of the Q3 charge accelerator. I want this to look very nice so I am taking my time doing the work.   First I ran the coil wires through the little holes in the stator half so that the wires can

Began Assembly Of Quanta Magnetics Q3 Charge Accelerator Generator

Today I began assembling the Quanta Magnetics Q3 charge accelerator. I have been studying everything I could find about this device for about 12 hours now and I feel that I am ready to begin assembly.   Lou, a disabled man had purchased this a few years ago to put together wi
Page Navigation: 1 2 3 (All)

Creation Crate

Most Viewed - Alternate Energy Projects